Rear Lower Arm

Removal

1. Remove the rear wheel and tire (A) from rear hub.

Tightening torque :
88.2 - 107.8 N.m (9.0 - 11.0 kgf.m, 65.0 - 79.5 lb-ft)

CAUTION:
Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).




2. Support the rear lower arm (A) with a jack as shown in the illustration.

NOTE:
Certainly install Jack as being danger because of the tension.




3. Loosen the bolt & nut and then remove the rear lower arm (A) with the rear axle.

Tightening torque :
137.3 - 156.9N.m (14.0 - 16.0kgf.m, 101.3 - 115.7lb-ft)




4. Loosen the bolt & nut and then remove the rear lower arm (B) with the sub frame (A).

Tightening torque :
137.3 - 156.9N.m (14.0 - 16.0kgf.m, 101.3 - 115.7lb-ft)




5. Installation is the reverse of removal.
6. Check the rear alignment.


Inspection

1. Check the bushing for wear and deterioration.
2. Check the rear lower arm for deformation.