Repair Procedures

Removal

1. Remove the air duct.

2. Remove the battery and the battery tray.

3. Remove the under cover (A).

Tightening torque :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)




4. Remove the drain plug (A) and reinstall the drain plug after draining ATF totally.

Drain plug tightening torque:
38.2 - 48.1 N.m (3.9 - 4.9 kgf.m, 28.2 - 35.4 lb-ft)





CAUTION:
Replace the gasket before reinstalling the drain plug.

5. Remove the wiring bracket installation bolt (A).




6. Remove the ATF Injection hole(eyebolt)(A).

Eyebolt tightening torque:
2.9 - 4.9 N.m (0.3 - 0.5 kgf.m, 2.2 - 3.6 lb-ft)





CAUTION:
Replace the O-Ring (A) before reinstalling the eyebolt.




7. Remove the valve body cover (A).

Tightening torque:
(A) 13.7 - 15.7N.m (1.4 - 1.6 kgf.m, 10.1 - 11.6lb-ft)





CAUTION:
- Replace the gasket (A) before reinstalling the valve body cover.





8. Remove the bolts (C) after disconnecting the solenoid valve connector (B) and the oil temperature sensor connector (A).

Tightening torque:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)




9. Remove the valve body assembly (A).

Tightening torque:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)





Installation

1. Installation is the reverse of removal.

NOTE:
- Adding Automatic Transaxle Fluid(ATF).

- Perform Transaxle Control Module(TCM) learning after replacing the valve body to prevent slow transaxle response, jerky acceleration and jerky startup.