A/T Does Not Shift: D3 -> D2

A/T Does Not Shift: 3rd gear -> 2nd gear

SYMPTOM: When shifted from 3[3] to 2[2] position, does not downshift from 3rd to 2nd gears.

DIAGNOSTIC PROCEDURE
1. CHECK SELF-DIAGNOSIS RESULTS
Perform self-diagnosis. Refer to AT-86, "SELF-DIAGNOSTIC RESULT MODE". Self-Diagnostic Result Mode
Do the self-diagnosis results indicate PNP switch, ATF pressure switch 6?
YES >> Check the malfunctioning system. Refer to AT-101, "DTC P0705 PARK/NEUTRAL POSITION SWITCH", AT-161, "DTC P1846 ATF PRESSURE SWITCH 6".
P0705
P1846
NO >> GO TO 2.

2. CHECK A/T FLUID LEVEL





Check the A/T fluid level.
OK or NG
OK >> GO TO 3.
NG >> Refill ATF.

3. CHECK CONTROL CABLE





Check the control cable.
^ Refer to AT-222, "Checking of A/T Position". Testing and Inspection
OK or NG
OK >> GO TO 4.
NG >> Adjust control cable.

4. CHECK A/T FLUID CONDITION
1. Remove oil pan.





2. Check A/T fluid condition. Refer to AT-51, "Fluid Condition Check". Fluid Condition Check
OK or NG
OK >> GO TO 5.
NG >> GO TO 8.

5. DETECT MALFUNCTIONING ITEM
^ Check the malfunction items. If any items are damaged, repair or replace damaged parts. Refer to AT-61, "Symptom Chart" (Symptom No.16). Symptom Chart
OK or NG
OK >> GO TO 6.
NG >> Repair or replace damaged parts.

6. CHECK SYMPTOM
Check again. Refer to AT-59, "Cruise Test - Part 3". Cruise Test - Part 3
OK or NG
OK >> INSPECTION END
NG >> GO TO 7.

7. PERFORM TCM INSPECTION
1. Perform TCM input/output signals inspection. Refer to AT-83, "TCM Input/Output Signal Reference Values". Pinout Values and Diagnostic Parameters
2. If NG, recheck A/T assembly harness connector terminals for damage or loose connection with harness connector.
OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.

8. DETECT MALFUNCTIONING ITEM
^ Check the malfunction items. If any items are damaged, repair or replace damaged parts. Refer to AT-61, "Symptom Chart" (Symptom No.16). Symptom Chart
OK or NG
OK >> GO TO 6.
NG >> Repair or replace damaged parts.