Section 5: Upgrading the MAP Data In the HDD Navigation System

SECTION 5: UPGRADING THE MAP DATA IN THE HDD NAVIGATION SYSTEM

^ Make sure to perform this operation on the same HDD navigation unit (vehicle) from which you generated the Certification Number.

^ Upgrading the map data cannot be performed by using an Install Key that was acquired by using a Certification Number generated from a different HDD navigation system.

^ Make sure to use the same the Consult PC that was used to generate the Certification Number.

1. Connect the Consult PC power cord (A.C. adapter or vehicle D.C. adapter).

^ Updating the map data will take a few minutes. Connecting the power cord will ensure the Consult PC maintains power during the update.

^ Vehicle ignition must remain OFF





2. Select Specialty Tools, Then HD Navi. Tools.





3. Select Install Map Update





4. Select Map update





5. Select NEXT





6. Carefully enter the Install Key.

7. Select NEXT





8. Confirm the version number of "New version of map data" is higher than "Current version of map data".

9. Select START





^ Map update will begin and a progress bar will be displayed as shown in Figure 5-7.





^ When update is complete the screen in Figure 5-8 will display.

10. Select OK

NOTE:
If the update does not complete correctly, do the following:

a. Perform Section 6: Disconnecting the Consult PC and CF Adaptor.

b. Make sure the vehicle battery is sufficiently charged.

c. Perform Section 2 again: Connecting the Consult PC to the HDD Navigation System.

d. Perform Section 5 again: Upgrading the Map Data in the HDD Navigation System.