Inspection Procedure

PLASMACLUSTER SYSTEM DOES NOT OPERATE


Inspection procedure


FUNCTION CONFIRMATION PROCEDURE
Check the plasmacluster operation in the function inspection.
1.CHECK PLASMACLUSTER ION CONTROL FUNCTION
1. Turn ignition switch OFF and restart the engine.
2. Ion indicator (blue) is shown on the display.
3. Press OFF switch.
4. Ion indicator is turned OFF.
Is the inspection result normal?
YES - GO TO 2.
NO - GO TO 3.
2.CHECK ION CONTROL MODE
1. Turn ignition switch OFF and restart the engine.
2. Press AUTO switch. AUTO INTAKE indicator turns ON (auto intake mode).
3. Ion indicator (blue) is shown on the display.
4. Ion indicator (blue) changes to ion indicator (green) after approximately 30 minutes.
5. Ion indicator (green) changes to ion indicator (blue) after approximately 15 minutes.
6. Press intake switch. AUTO INTAKE indicator and REC indicator turns OFF (fixed FRE mode).
7. Ion indicator (green) changes to ion indicator (blue) after approximately 15 minutes.
8. Ion indicator (blue) changes to ion indicator (green) after approximately 15 minutes.
Is the inspection result normal?
YES - GO TO 3.
NO - Replace unified meter and A/C amp.
3.PERFORM SELF-DIAGNOSIS
Perform self-diagnosis function STEP-4. Refer to Diagnosis Description.





Does plasmacluster system change according to each code No.?
YES - INSPECTION END
NO-1 - Ionizer operation is malfunctioning. Refer to Diagnosis Procedure.
NO-2 - Ion indicator does not change. Replace unified meter and A/C amp.
NO-3 - Ion indicator does not illuminate. Refer to Bose Audio (WITHOUT NAVIGATION) AV-564, "Symptom Table" [NAVIGATION (SINGLE MONITOR)] or Navigation (Twin Monitor)
[NAVIGATION (TWIN MONITOR)].