Engine Harness - MIL ON/DTC's Set/No Start: Overview

Classification:
EC01-031A

Reference:
ITB01-072A

Date:
January 9, 2002

2000 - 2001 I30 EGI HARNESS WIRE BREAKAGE

ATTENTION:
This bulletin Amends the Claims Information section of ITB01-072. Please discard all paper copies of ITB01-072.

APPLIED VEHICLES:
2000 - 2001 I30 (CA33)

SERVICE INFORMATION

If a 2000 - 2001 I30 has any of the following symptoms:

^ MIL "ON" and/or Diagnostic Trouble Code (DTC) stored in Self-Diagnosis,

^ Engine no start,

^ Other system malfunctions such as A/C inop, A/C idle up inop, rough idle, oil pressure light inop,





The cause may be wire breakage in the engine control harness where it bends over the right rear of the engine next to the right strut tower (see Figure 1).











^ See the Engine/Transmission DTC Charts shown for the possible DTC that may be caused by this incident, if it should occur.





^ See the Symptom Chart shown for possible symptoms that that may be caused by this incident, if it should occur.

These repair procedures may apply to your DTC or symptom if it is specifically listed on the charts. Please note the following:

^ Only incidents and circuits listed on the charts are applicable to this bulletin.

^ All of the incident possibilities are circuits contained in wiring that pass through the bend in the engine control harness.

^ For each DTC or symptom listed there can be more than one circuit to check.





PARTS INFORMATION

CLAIMS INFORMATION





Submit a Primary Failed Part (PP) line claim using the claims coding table as shown.