3: Slip, TCS Off Indicator and ABS Warning Lamp

BASIC INSPECTION 3: SLIP, TCS OFF INDICATOR AND ABS WARNING LAMP
1. Turn ignition switch "ON" to ensure that TCS OFF indicator lights. If TCS OFF indicator does not light, check TCS OFF circuit.
(Refer to diagnostic procedure 24 "TCS OFF indicator does not come on when ignition switch is turned on" under "TROUBLE DIAGNOSES FOR SYMPTOMS".)
2. Turn ignition switch "ON" to ensure that SLIP indicator lights. If SLIP indicator does not light, check SLIP indicator circuit.
(Refer to diagnostic procedure 23 "SLIP indicator does not come on when ignition switch is turned on" under "TROUBLE DIAGNOSES FOR SYMPTOM".)
3. Turn ignition switch "ON" to ensure that ABS warning lamp lights. If ABS warning lamp does not light, check ABS warning lamp circuit.
(Refer to diagnostic procedure 25 "ABS warning lamp does not come on when ignition switch is turned on" under "TROUBLE DIAGNOSES FOR SYMPTOM".)
4. Check to ensure that SLIP indicator and ABS warning lamp go out approximately 1 second after engine starts. If SLIP indicator and ABS warning lamp do not go out, perform self-diagnostic procedures.
5. After driving vehicle at 30 km/h (19 MPH) for more than 1 minute, check to ensure that SLIP indicator and ABS warning lamp remain off. If SLIP indicator and ABS warning lamp light, perform self-diagnostic procedures.
6. While running engine, turn TCS OFF switch "ON" and "OFF" to ensure that TCS OFF indicator lights and goes out correspondingly. If TCS OFF indicator does not correspond with switch operation, check TCS OFF switch circuit.
(Refer to Diagnostic Procedure 27 "INOPERATIVE TCS OFF SWITCH" under "TROUBLE DIAGNOSES FOR SYMPTOM".)
7. Start engine TCS OFF switch "OFF") to ensure that TCS OFF indicator goes out. If TCS OFF indicator remains on for more than 10 seconds after engine starts, perform self-diagnostic procedures.
8. Drive vehicle at 30 km/h (119 MPH) for more than 1 minute to ensure that TCS OFF indicator remains off. If TCS OFF indicator lights, perform self-diagnostic procedures.
9. After performing self-diagnostic procedures, be sure to erase trouble stored in memory.