Active Test Procedure

ACTIVE TEST PROCEDURE





1. Connect CONSULT-II to data link connector, then start the engine.





2. Touch "START", "ACT D/SUS" and "ACTIVE TEST".





3. Touch "INDICATOR" or "DAMPER" as required.





- When "INDICATOR" is to be selected:
1) Touch "MAIN SIGNAL", then "START".





2) When "OFF" is touched, indicator lamp goes out regardless of select switch positions. Monitor indicator will then be turned "OFF".
3) When "ON" is touched, indicator lamp comes on regardless of select switch positions. Monitor indicator will then be turned "ON".





- When "DAMPER" is to be selected:
1) Touch "SELECTION FROM MENU".
2) Select and touch "DAMP MTR F/R" or "DAMP MTR F/L", and "DAMP MTR R/R" or "DAMP MTR R/L", as required.
3) Touch "ENTER", then "START".





4) "4 step" for front damper motors and "4 step" for rear damper motor will be then shown on the display.
5) Touch "CONDITION CHANGE", "FL-N, FR-N, RL-N, RR-N" and "START".





6) "96 step" for front damper motors and "96 step" for rear damper motor will then appear on the display.
7) Touch "CONDITION CHANGE", "FL-HS, FR-HS, RL-HS, RR-HS" and "START".





8) "0 step" for front damper motors and "0 step" for rear damper motor will then appear on the display.
9) Touch "CONDITION CHANGE" and "FL-SS, FR-SS, RL-SS, RR-SS" and "START".





10) "-40 step" for front damper motors and "-40 step" for rear damper motor will then appear on the display.
11) Print out data as required.