Engine Control Module

ECM Harness Connector Terminal Layout:

ECM Inspection Table Part 1:

ECM Inspection Table Part 2:

ECM Inspection Table Part 3:

ECM Inspection Table Part 4:

ECM Inspection Table Part 5:

ECM Inspection Table Part 6:

ECM Inspection Table Part 7:

ECM Inspection Table Part 8:

ECM Inspection Table Part 9:

ECM Inspection Table Part 10:

ECM INSPECTION TABLE
Specification data are reference values and are measured between each terminal and ground.

Pulse signal is measured by CONSULT-II.

CAUTION: Do not use ECM ground terminals when measuring the input/ output voltage. Doing so may result in damage to the ECM's transistor. Use ground other than the ECM terminals, such as the ground.