Removal and Installation

REMOVAL




1. Open the driver and front passenger window, and then disconnect the battery cable from the negative terminal or remove power fuse.

CAUTION: After battery cables are disconnected, never open/close the driver and/or front passenger door with the window in the full up position. The automatic window adjusting function will not work and the side roof panel may be damaged.

2. Remove front grille. Refer to "FRONT GRILLE" in "EI" section.
3. Remove front undercover and fender protector. Refer to "FENDER PROTECTOR" in "EI" section.




4. Remove mounting clip on top of front bumper and screws on side of front bumper. Refer to "FRONT BUMPER" in "EI" section.
5. Pull side of front bumper toward the vehicle front and disengage it from clips on the body.
6. Remove headlamp mounting bolts.
7. Pull headlamp toward the vehicle front, disconnect connector, and remove headlamp.

CAUTION: When removing headlamps, put a shop cloth or something similar between headlamps and bumper to protect bumper.

INSTALLATION
Installation is the reverse order of removal.

Headlamp mounting bolt: 5.0 Nm (0.51 kg-m, 44 in-lb)