Sunroof Unit

SUNROOF UNIT







Removal

CAUTION:
- Always work with a helper.
- When taking sunroof unit out, use cloths to protect the seats and trim from damage.
- After installing the sunroof unit and glass lid, be sure to check gap adjustment to ensure it is within the standard.

1. Remove headlining.
2. Disconnect drain hoses.
3. Remove glass lid. Refer to "GLASS LID".
4. Disconnect connector from sunroof motor.
5. Remove TORX bolts (T25) from the front end.
6. Remove nuts from side rails.
7. Remove bolts from front sunroof bracket.
8. Remove bolts from rear sunroof bracket, and then remove sunroof unit from roof panel.
9. Remove sunroof unit through the passenger compartment while being careful not to damage the seats and trim.

Installation
1. Temporarily tighten the mounting bolts to the rear sunroof brackets.
2. Bring sunroof unit into passenger compartment and place the rear end of the rail onto the rear sunroof brackets.
3. Temporarily tighten the nuts to the side rail.
4. Temporarily tighten the TORX bolts (T25) to the front end.
5. Tighten the installation point bolts diagonally excluding the installation point of the sunroof bracket around the roof opening.
6. Tighten the vehicle side bolts of the front sunroof bracket.
7. Tighten the vehicle side bolts of the rear sunroof bracket.
8. Tighten the TORX bolts (T25) to the front end and nuts to the side rail.
9. Install glass lid. Refer to "GLASS LID".
10. Connect drain hoses.
11. Install headlining. Refer to "Removal and Installation"