Preparation (Sedan and Coupe)

Preparation (Sedan & Coupe) for Side Air Bag and Seat Belt Tension Senor Connector Kit Installations





1. Write down all radio station presets.

2. If equipped, write down / record the following customer settings for the ATC (Automatic Temperature Control) system. (Refer to the Service Manual as needed):

^ Temperature Setting Trimmer

^ Foot Position Setting Trimmer

^ Inlet Port Memory Function

3. Move both front seats forward and remove the rear mounting bolts for both front seats.

4. Move both front seats to the full rear position.

5. Adjust the seatback (recline) on both front seats to the full forward position.

6. Remove the front seat mounting bolts for both front seats.

7. Make sure the ignition is OFF and disconnect both battery cables (negative cable first).

8. Wait at least 3 minutes after the battery cables are disconnected.

IMPORTANT:
Follow all cautions, warnings, and notes in the Electronic Service Manual (ESM) when working on or near a Supplemental Restraint System (SRS), such as an airbag.





9. Tip both front seats backward as far as possible without overstretching the seat wiring harness.

^ Sedan passenger seat shown, other applied seats are similar.

NOTE:
Use covers as needed to protect seats and other interior surfaces.