Service Notice or Precaution

Service Notice or Precaution
^ Do not reuse transfer fluid, once it has been drained.
^ Check the fluid level or replace the fluid only with the vehicle parked on level ground.
^ During removal or installation, keep inside of transfer clear of dust or dirt.
^ Replace all tires at the same time. Always use tires of the proper size and the same brand and pattern. Fitting improper size and unusual wear tires applies excessive force to vehicle mechanism and can cause longitudinal vibration.
^ Disassembly should be done in a clean work area, it is preferable to work in dust proof area.
^ Before proceeding with disassembly, thoroughly clean the transfer. It is important to prevent the internal parts from becoming contaminated by dirt or other foreign matter.
^ All parts should be carefully cleaned with a general purpose, nonflammable solvent before inspection or reassembly.
^ Check for the correct installation status prior to removal or disassembly. If matching marks are required, be certain they do not interfere with the function of the parts when applied.
^ Check appearance of the disassembled parts for damage, deformation, and unusual wear. Replace them with a new ones if necessary.
^ Gaskets, seals and O-rings should be replaced any time when the transfer is disassembled.
^ In principle, tighten bolts or nuts gradually in several steps working diagonally from inside to outside. If tightening sequence is specified, use it.
^ Observe the specified torque when assembling.
^ Clean and flush the parts sufficiently and blow-dry them.
^ Be careful not to damage sliding surfaces and mating surfaces.
^ Clean inner parts with lint free cloth or towels. Do not use cotton work gloves and rags to prevent adhering fibers.