With Manufacturer's Scan Tool

CONSULT-II Inspection Procedure

CAUTION: If CONSULT-II is used with no connection CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which performs CAN Communication.

BASIC OPERATION
1. Turn ignition switch OFF.




2. Connect CONSULT-II CONVERTER and CONSULT-II to data link connector (1).




3. Use mechanical key to turn ignition switch to ON.
4. Touch "START (NISSAN BASED VHCL)".




5. Touch "INTELLIGENT KEY" on "SELECT SYSTEM" screen. If "INTELLIGENT KEY" is not indicated, go to GI-41, "CONSULT-II Data Link Connector (DLC) Circuit". Schematic




6. Select diagnosis mode. "WORK SUPPORT", "SELF-DIAG RESULTS", "CAN DIAG SUPPORT MNTR", "DATA MONITOR", "ACTIVE TEST" and "ECU PART NUMBER" are available.