Transmitter ID Registration Procedure
ID REGISTRATION WITH ACTIVATION TOOLThis procedure must be done after replacement of a tire pressure transmitter, low tire pressure warning control unit, or tire rotation.
CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunction might be detected during self-diagnosis depending on control unit which performs CAN communication.
1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.
3. Turn ignition switch ON.
4. Touch "START (NISSAN BASED VHCL)" "AIR PRESSURE MONITOR".
^ If "AIR PRESSURE MONITOR" is not displayed, print the "SELECT SYSTEM" screen.
NOTE: Just after starting engine, or turning ignition switch ON, it may not be displayed even if "START (NISSAN BASED VHCL)" is touched. In this case, reconnect CONSULT-II and CONSULT-II CONVERTER.
5. Touch "WORK SUPPORT" on "SELECT DIAG MODE" screen.
6. Touch "ID REGIST" on "SELECT WORK ITEM".
7. With the activation tool [SST: J-45295] pushed against the front left tire pressure transmitter position of the tire air valve, press and hold the button for 5 seconds.
8. Register the IDs in order from FR LH, FR RH, RR RH, RR LH. When ID registration of each wheel has been completed, a buzzer sounds and turn signal lamp blinks.
9. After completing all ID registrations, press "END" to complete the procedure.
NOTE: Be sure to register the IDs in order from FR LH, FR RH, RR RH, to RR LH, or the self-diagnosis results display will not function properly
ID REGISTRATION WITHOUT ACTIVATION TOOL
This procedure must be done after replacement of a tire pressure transmitter, low tire pressure warning control unit, or tire rotation.
CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunction might be detected during self-diagnosis depending on control unit which performs CAN communication.
1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.
3. Turn ignition switch ON.
4. Touch "START (NISSAN BASED VHCL)" "AIR PRESSURE MONITOR".
^ If "AIR PRESSURE MONITOR" is not displayed, print the "SELECT SYSTEM" screen.
NOTE: Just after starting engine, or turning ignition switch ON, it may not be displayed even if "START (NISSAN BASED VHCL)" is touched. In this case, reconnect CONSULT-II and CONSULT-II CONVERTER.
5. Touch "WORK SUPPORT" on "SELECT DIAG MODE" screen.
6. Touch "ID REGIST" on "SELECT WORK ITEM".
7. Adjust the tire pressure to the values shown in the table for ID registration, and drive the vehicle at 40 km/h (25 MPH) or more for a few minutes.
8. After completing all ID registrations, press "END" to complete the procedure.
9. Inflate all tires to proper pressure.