CONSULT-II Inspection Procedure

CONSULT-II INSPECTION PROCEDURE

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.




1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.
3. Turn ignition switch ON.




4. Touch "START (NISSAN BASED VHCL)".




5. Touch "AUTO DRIVE POS".
If AUTO DRIVE POS. is not indicated, refer to "CONSULT-II Data Link Connector (DLC) Circuit".




6. Select diagnosis mode.
"DATA MONITOR", "ACTIVE TEST", "SELF-DIAG RESULTS", "ECU PART NUMBER" and "WORK SUPPORT" are available.

Display Item List - Self Diagnosis Results:

SELF-DIAGNOSIS RESULTS