Section 5

Section 5: Again, perform a check of all Systems in "SELF-DIAG RESULTS" and erase any newly stored DTCs.

1. Remove the 8 MB orange Reprogramming Card from CONSULT-II.

2. Install the red/white Diagnostic Card into Slot A (top slot) of CONSULT-II.

3. Turn the ignition switch ON (do not start the engine).

^ CONSULT-II will turn ON automatically.

^ Confirm that all electrical loads* (except for the ignition) are OFF.

* Headlights defroster A/C audio (radio) video cellular telephone etc.

4. Press [START (Nissan BASED VHCL)]

5. In "SELF-DIAG RESULTS" check and erase any DTCs in the below noted vehicle systems:

IMPORTANT:
You MUST press "ERASE" and "OK" in all systems (shown below) whether a DTC is displayed or not. This is required to complete the VDC reprogramming procedure, and it will make sure that all DTCs are erased.

^ ENGINE

^ A/T

^ ABS

^ AIR BAG

^ ALL MODE AWD/4WD (if applicable)

^ DIFF LOCK (if applicable; 4WD Titan)

^ AIR LEVELIZER (if applicable)

6. After all DTCs are erased:

^ Turn the ignition switch OFF.

^ Disconnect CONSULT-II and the CAN Cable from the vehicle connector.

^ Disconnect the battery charger from the vehicle.

^ Start the engine and make sure it runs properly and there are NO warning lights illuminated in the instrument panel.

7. Continue with Part 4.