ID Registration Cannot Be Completed

ID REGISTRATION CANNOT BE COMPLETED

Description

DESCRIPTION
The ID of the transmitter installed in each wheel cannot be registered in the tire pressure monitoring system. Inspect the transmitter or the tire pressure monitoring system circuit.

Diagnosis Procedure

1.CHECK ID REGISTRATION
1. Perform ID registration of all transmitter. Refer to WT-5, "ID REGISTRATION PROCEDURE: Special Repair Requirement". Transmitter ID Registration Procedure
2. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes. Then check all tire pressures with CONSULT-III "DATA MONITOR" within 5 minutes.





Does "DATA MONITOR" displayed the standardized value without turning low tire pressure warning lamp ON?
YES >> INSPECTION END
NO >> GO TO 2.

2.CHECK TRANSMITTER
1. Perform trouble diagnosis for transmitter. Refer to WT-17, "Diagnosis Procedure". C1708
2. Perform ID registration of all transmitter. Refer to WT-5, "ID REGISTRATION PROCEDURE: Special Repair Requirement". Transmitter ID Registration Procedure
Can ID registration of all transmitters be completed?
YES >> INSPECTION END
NO >> Repair or replace the malfunctioning connector. Repair or replace the malfunctioning part. GO TO 1.