Tightening Torque and Sequence
Intake ManifoldIf stud bolts were removed, install them and tighten to the torque specified below.
Torque 10.8 Nm (1.1 kg-m, 8 ft-lb)
Tighten all mounting bolts to the specified torque in two or more steps in numerical order as shown in the figure.
<---: Engine front
CAUTION:
Install intake manifold with the marks (put on the intake manifold and the cylinder head before removal) aligned.
Tighten mounting bolts from the outside of manifold to the inside.
1st step 7.4 Nm (0.75 kg-m, 5 ft-lb)
2nd step and after 25.5 Nm (2.6 kg-m, 19 ft-lb)