Control Device

CONTROL DEVICE

TM-227 Exploded View:

Removal and Installation

REMOVAL
1. Disconnect lower lever of control device and control rod.
2. Shift the selector lever to "N" position.





3. Remove knob cover (A) below selector lever downward.
4. Pull lock pin (1) out of selector lever knob (2).
5. Remove selector lever knob (2).
6. Remove console finisher assembly, rear upper console assembly and console front bracket.
7. Disconnect A/T device harness connector.
8. Remove control device assembly.
9. Remove the following parts if necessary.
a. Selector lever position indicator





i. Remove the cigarette lighter harness connector (A) from the console finisher assembly.
<---: Screw
ii. Remove the insert finisher (1) from the console finisher.
iii. Remove the selector lever position indicator.
b. Shift lock unit
i. Remove the shift lock unit from the control device assembly.

INSTALLATION
Install in the reverse order of removal.

Inspection and Adjustment

ADJUSTMENT AFTER INSTALLATION
Adjust the A/T positions after installing the control device. Refer to TM-226, "Inspection and Adjustment". Testing and Inspection

INSPECTION AFTER INSTALLATION
Check the A/T positions after adjusting the A/T positions. Refer to TM-226, "Inspection and Adjustment". Testing and Inspection