Rear Final Drive Assembly
REAR FINAL DRIVE ASSEMBLYDLN-36 Exploded View:
Removal and Installation
REMOVAL
1. Remove center muffler with a power tool.
2. Remove rear stabilizer bar with a power tool.
3. Remove propeller shaft from the final drive.
4. Remove drive shaft from final drive with a power tool. Then suspend it by wire, etc.
5. Remove breather hose from the final drive.
6. Remove rear wheel sensor.
7. Set a suitable jack to rear final drive assembly.
CAUTION:
Never place a jack on the rear cover (aluminum case).
8. Remove the mounting bolts and nuts connecting to the suspension member, and remove rear final drive assembly with a power tool.
CAUTION:
Secure rear final drive assembly to a suitable jack while removing it.
INSTALLATION
Note the following, and installation is in the reverse order of removal.
^ When installing breather hoses (1), refer to the figure.
<---: Vehicle front
CAUTION:
Make sure there are no pinched or restricted areas on the breather hose caused by bending or winding when installing it.
- For installation, insert the vehicle side end to suspension member (2). Install metal connector (3) side of this hose to rear cover by inserting it with aiming painted marking to the front of vehicle.
^ When oil leaks while removing final drive assembly, check oil level after the installation. Refer to DLN-26, "Inspection". Rear Final Drive: R200