Removal and Installation

BACK DOOR


BACK DOOR ASSEMBLY : Removal and Installation


CAUTION:
Operate with two workers, because of its heavy weight.

NOTE:
The back door harness constitute the back door assembly.

REMOVAL
1. Remove back door finisher inner, back door plate, back door hinge cover. Refer to .
2. Remove clips of head lining at rear end. Refer to Removal and Installation(NORMAL ROOF) or Removal and Installation (SUNROOF).





3. Disconnect harness connectors and bolts as shown in the figure by arrows.
4. Remove grommet (LH) (1), and then pull harness out of vehicle at roof panel (2) hole.





5. Remove grommet (RH), and then disconnect washer tube (1).
6. Pull washer tube out of back door.
7. Support back door lock with the proper material to prevent it from falling.

WARNING:
Body injury may occur if no supporting rod is holding the back door open when removing the back door stay.
8. Remove back door stay. Refer to .
9. Remove back door hinge mounting bolts on back door and remove back door assembly.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- Check back door open/close, lock/unlock operation after installation.
- After installation, perform fitting adjustment. Refer to .