Removal and Installation

CRASH ZONE SENSOR


Removal and Installation


WARNING:
- Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait at least 3 minutes or more.
- Never use the air tools or electric tools for servicing.

REMOVAL
1. Remove the reservoir tank. Refer to Removal and Installation.
2. Remove the crash zone sensor fixing nuts.
3. Disconnect the crash zone sensor harness connector.

CAUTION:
- Never impact the crash zone sensor.





- Replace the crash zone sensor if it has been dropped or sustained an impact.
- Replace the crash zone sensor of deployed driver air bag and deployed front passenger air bag.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- Never use the old fixing nuts after removal, replace with the new nuts.
- If malfunction is detected by the air bag warning lamp, after repair or replacement of the malfunctioning parts, reset the memory using self-diagnosis or CONSULT-III. Refer to Consult-III Function, "CONSULT-III
Function".
- After the work is completed, check that no system malfunction is detected by air bag warning lamp.