Removal and Installation

REAR OIL SEAL


AWD : Removal and Installation


REMOVAL
1. Remove exhaust front tube and center muffler with power tool. Refer to Exploded View.
2. Remove rear propeller shaft. Refer to Exploded View.
3. Remove exhaust mounting bracket. Refer to Exploded View.
4. Remove three way catalyst (right bank). Refer to Exploded View
5. Remove front propeller shaft. Refer to Exploded View.
6. Remove transfer assembly from A/T assembly. Refer to Exploded View.





7. Remove rear oil seal (1) with a flat-bladed screwdriver (A).

CAUTION:
Be careful not to scratch adapter case assembly.

INSTALLATION
Note the following, and install in the reverse order of removal.





- As shown in the figure, use the drift [64 mm (2.52 in) dia. commercial service tool] (A) to drive rear oil seal into adapter case assembly until it is flush.

CAUTION:
- Never reuse rear oil seal.
- Apply [1][2]ATF to rear oil seal.