C1A35

C1A35 ACCELERATOR PEDAL ACTUATOR





Description
- The accelerator pedal actuator is integrated into the accelerator pedal assembly.
- The accelerator pedal actuator consists of the control unit and motor.




DTC Logic

DTC DETECTION LOGIC

DTC DETECTION LOGIC:

Diagnosis Procedure
1.PERFORM THE SELF-DIAGNOSIS
1. Start the engine.
2. Turn the DCA switch ON.
3. Perform "All DTC Reading" with CONSULT-III.
4. Check if the "C1A35" is detected as the current malfunction in self-diagnosis results of "ICC".
Is "C1A35" detected as the current malfunction?
YES - Replace the accelerator pedal assembly.
NO - INSPECTION END




Special Repair Requirement

DESCRIPTION
The accelerator pedal released position learning is necessary when the following operation is performed.
- Disconnection and connection of accelerator pedal assembly connector
- Replace accelerator pedal assembly

SPECIAL REPAIR REQUIREMENT
1.ACCELERATOR PEDAL RELEASED POSITION LEARNING
Perform the accelerator pedal released position learning. Refer to Special Repair Requirement Description Special Repair Requirement Description Special Repair Requirement Description.
- GO TO 2.
2.CHECK DCA SYSTEM
1. Erase the "self-diagnosis results", and then perform "All DTC Reading" again after performing the action test. (Refer to DCA for action test.)
2. Check that the DCA system is normal.
- WORK END