C1F03

C1F03 ACCELERATOR PEDAL ACTUATOR





Description
The accelerator pedal actuator is integrated into with a temperature sensor.




DTC Logic

DTC DETECTION LOGIC

DTC DETECTION LOGIC:

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn the ignition switch OFF.
2. Wait for 10 minutes or more and cool the accelerator pedal actuator integrated motor.
3. Drive the vehicle with DCA switch ON and operate the system.

CAUTION:
Always drive safely.
4. Stop the vehicle.
5. Perform "All DTC Reading" with CONSULT-III.
6. Check if the DTC "C1F03" is detected as the current malfunction in self-diagnosis results of "ACCELE
PEDAL ACT".
Is "C1F03" detected as the current malfunction?
YES - Refer to C1F03.
NO - Refer to Intermittent Incident.




Diagnosis Procedure
1.REPLACE ACCELERATOR PEDAL ASSEMBLY
Perform DTC confirmation procedure. If "C1F03" is detected, replace the accelerator pedal assembly. Refer to C1F03.
- INSPECTION END




Special Repair Requirement

DESCRIPTION
The accelerator pedal released position learning is necessary when the following operation is performed.
- Disconnection and connection of accelerator pedal assembly connector
- Replace accelerator pedal assembly

SPECIAL REPAIR REQUIREMENT
1.ACCELERATOR PEDAL RELEASED POSITION LEARNING
Perform the accelerator pedal released position learning. Refer to Special Repair Requirement Description Special Repair Requirement Description Special Repair Requirement Description
- GO TO 2.
2.CHECK DCA SYSTEM
1. Erase the "self-diagnosis results", and then perform "All DTC Reading" again after performing the action test. (Refer to DCA for action test.)
2. Check that the DCA system is normal.
- WORK END