DCA

U1010 CONTROL UNIT (CAN)





ICC SENSOR INTEGRATED UNIT : Description
CAN controller controls the communication of CAN communication signal and the error detection.




ICC SENSOR INTEGRATED UNIT : DTC Logic

DTC DETECTION LOGIC

DTC DETECTION LOGIC:

ICC SENSOR INTEGRATED UNIT : Diagnosis Procedure
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn the DCA switch ON.
2. Perform "All DTC Reading" with CONSULT-III.
3. Check if the "U1010" is detected as the current malfunction in self-diagnosis results of "ICC".
Is "U1010" detected as the current malfunction?
YES - Replace the ICC sensor integrated unit.
NO - INSPECTION END




ICC SENSOR INTEGRATED UNIT : Special Repair Requirement

DESCRIPTION
Perform the action test after adjusting the laser beam aiming of ICC sensor integrated unit when the following operation is performed.
- Removal and installation of ICC sensor integrated unit
- Replacement of ICC sensor integrated unit

SPECIAL REPAIR REQUIREMENT
1.LASER BEAM AIMING ADJUSTMENT OF ICC SENSOR INTEGRATED UNIT
Adjust the laser beam aiming of the ICC sensor integrated unit. Refer to ICC (Full Speed Range) ICC (Full Speed Range) Description
- GO TO 2.
2.CHECK DCA SYSTEM
1. Erase the "self-diagnosis results", and then perform "All DTC Reading" again after performing the action test. (Refer to DCA for action test.)
2. Check that the DCA system is normal.
- WORK END




ACCELERATOR PEDAL ACTUATOR : Description
CAN controller controls the communication of ITS communication signal and the error detection.




ACCELERATOR PEDAL ACTUATOR : DTC Logic

DTC DETECTION LOGIC

DTC DETECTION LOGIC:

ACCELERATOR PEDAL ACTUATOR : Diagnosis Procedure
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn the DCA switch ON.
2. Perform "All DTC Reading" with CONSULT-III.
3. Check if the DTC "U1010" is detected as the current malfunction in self-diagnosis results of "ACCELE
PEDAL ACT".
Is "U1010" detected as the current malfunction?
YES - Replace the accelerator pedal assembly.
NO - INSPECTION END




ACCELERATOR PEDAL ACTUATOR : Special Repair Requirement

DESCRIPTION
The accelerator pedal released position learning is necessary when the following operation is performed.
- Disconnection and connection of accelerator pedal assembly connector
- Replace accelerator pedal assembly

SPECIAL REPAIR REQUIREMENT
1.ACCELERATOR PEDAL RELEASED POSITION LEARNING
Perform the accelerator pedal released position learning. Refer to Special Repair Requirement Description Special Repair Requirement Description Special Repair Requirement Description
- GO TO 2.
2.CHECK DCA SYSTEM
1. Erase the "self-diagnosis results", and then perform "All DTC Reading" again after performing the action test. (Refer to DCA for action test.)
2. Check that the DCA system is normal.
- WORK END