Special Repair Requirement

INSPECTION AND ADJUSTMENT


SYSTEM SETTING : Special Repair Requirement

1. CHOOSE METHOD
There are three way of setting method.
Which method do you choose?
With display-GO TO 2.
With set switch-GO TO 4.
With CONSULT-III-GO TO 6.
2. WITH DISPLAY - STEP 1
Turn ignition switch ON.
- GO TO 3.
3. WITH DISPLAY - STEP 2
1. Push "SETTING" button.
2. Select "Comfort and convenience".
3. Select "Lift Steering Wheel ON Exit"or "Slide Driver's Seat Back ON Exit" on display, then push
- Lift Steering Wheel ON Exit: Entry/exit assist (steering column)
- Slide Driver's Seat Back On Exit: Entry/exit assist (seat)
- END
4. WITH SET SWITCH - STEP 1
1. Turn ignition switch OFF.
2. Push setting button and hold for more than 10 seconds, then confirm blinking of the memory switch indicator.
- Entry/exit assist (seat/steering column) are ON: Memory switch indicator blink two times.
- Entry/exit assist (seat/steering column) are OFF: Memory switch indicator blink once.
- GO TO 5.
5. WITH SET SWITCH - STEP 2
1. Turn ignition switch ACC
2. Push setting button and hold for more than 10 seconds, then confirm blinking of the memory switch indicator.
- Seat synchronization are ON: Memory switch indicator blink two times.
- Seat synchronization are OFF: Memory switch indicator blink once.
- END
6. WITH CONSULT-III - STEP 1
Select "Work support".
- GO TO 7.
7. WITH CONSULT-III - STEP 2
1. Select "EXIT SEAT SLIDE SETTING", "EXIT TILT SETTING" or "SEAT SLIDE VOLUME SET" then touch display to change between ON and OFF.
- EXIT SEAT SLIDE SETTING: Entry/exit assist (seat)
- EXIT TILT SETTING: Entry/exit assist (steering column)
2. Then touch "OK".
- END