ICC (Full Speed Range)

CHIME DOES NOT SOUND


Description

Symptom check: In the following conditions, the warning chime may not sound even if the vehicle distance is short.
- When the vehicles are traveling at the same speed and the distance between vehicles is not changing.
- When the vehicle ahead is traveling faster and the distance between vehicles is increasing.
- The warning chime will not sound when the accelerator pedal is depressed, overriding the system.
- The warning chime will not sound when own vehicle approaches vehicles that are parked or moving slowly.
- The warning chime does not sound when the system does not detect any vehicle ahead. (Diagnose the conditions under which the system is detecting the vehicle ahead and when the system is malfunctioning. If there is any malfunction in detecting the vehicle ahead, check the system following the ICC (Full Speed Range).)




CHIME DOES NOT SOUND


Diagnosis Procedure

1.PERFORM ACTIVE TEST
Check if the warning chime sounds on the active test item "ICC BUZZER" of "ICC" with CONSULT-III.
Does the warning chime sound?
YES - GO TO 2.
NO - GO TO 3.
2.CHECK THE MALFUNCTION SYMPTOM DURING WARNING CHIME OPERATION
1. Understand the vehicle ahead detecting condition when the malfunction occurred. If the warning chime should have sounded, replace the ICC sensor integrated unit. Refer to ICC (Full Speed Range).
2. Adjust the laser beam aiming. Refer to Description.
- GO TO 8.
3.CHECK WARNING CHIME CIRCUIT
Check the ICC warning chime circuit. Refer to ICC (Full Speed Range).
Is the inspection result normal?
YES - GO TO 4.
NO - GO TO 6.
4.PERFORM THE SELF-DIAGNOSIS
1. Perform "All DTC Reading" with CONSULT-III.
2. Check if the "U1000" is detected in self-diagnosis results of "ICC".
Is "U1000" detected?
YES - GO TO 5.
NO - GO TO 7.
5.CAN COMMUNICATIONS SYSTEM INSPECTION
Check the CAN communication system and repair or replace malfunctioning parts. Refer to ICC (Full Speed Range) ICC (Full Speed Range) ICC (Full Speed Range) ICC (Full Speed Range)
- INSPECTION END
6.REPAIR OR REPLACE MALFUNCTIONING PARTS
Repair or replace malfunctioning parts.
- GO TO 8.
7.REPLACE ICC SENSOR INTEGRATED UNIT
1. Replace the ICC sensor integrated unit. Refer to ICC (Full Speed Range).
2. Adjust the laser beam aiming. Refer to Description.
- GO TO 8.
8.CHECK ICC SYSTEM
1. Erase the self-diagnosis results, and then perform "All DTC Reading" again after performing the action test. (Refer to ICC (Full Speed Range) for action test.)
2. Check that the ICC system is normal.
- INSPECTION END