Diagnosis Procedure

SEAT BELT BUCKLE SWITCH (PASSENGER SIDE)


PRE-CRASH SEAT BELT SYSTEM : Diagnosis Procedure

1.CHECK PRE-CRASH SEAT BELT CONTROL UNIT INPUT SIGNAL
Check that voltage between seat belt buckle switch (passenger side) and ground.





Is the inspection result normal?
YES - Seat belt buckle switch (passenger side) circuit is normal.
NO - GO TO 2.
2.CHECK SEAT BELT BUCKLE (PASSENGER SIDE) SWITCH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect pre-crash seat belt control unit (passenger side) connector and seat belt buckle switch (passenger side) connector.
3. Check continuity between pre-crash seat belt control unit (passenger side) and seat belt buckle switch
(passenger side).





4. Check continuity between pre-crash seat belt control unit (passenger side) and ground.





Is the inspection result normal?
YES - GO TO 3.
NO - Repair or replace harness between pre-crash seat belt control unit (passenger side) and seat belt buckle switch (passenger side).
3.CHECK SEAT BELT BUCKLE SWITCH GROUND CIRCUIT
Check continuity between seat belt buckle switch (passenger side) and ground.





Is the inspection result normal?
YES - GO TO 4.
NO - Repair or replace harness between seat belt buckle switch and ground.
4.CHECK SEAT BELT BUCKLE SWITCH (PASSENGER SIDE)
Check seat belt buckle switch (passenger side). Refer to Component Inspection (Belt Buckle Switch).
Is the inspection result normal?
YES - Replace pre-crash seat belt control unit (passenger side).
NO - Replace seat belt buckle switch (passenger side).