Diagnosis Procedure

REAR WIPER AUTO STOP SIGNAL CIRCUIT


Diagnosis Procedure

1.CHECK REAR WIPER MOTOR (AUTO STOP) OUTPUT VOLTAGE
1. Turn the ignition switch OFF.
2. Disconnect rear wiper motor connector.
3. Turn the ignition switch ON.
4. Check voltage between BCM harness connector and ground.





Is the measurement value normal?
YES - GO TO 3.
NO - GO TO 2.
2.CHECK REAR WIPER MOTOR (AUTO STOP) SHORT CIRCUIT
1. Turn the ignition switch OFF.
2. Disconnect BCM connector.
3. Check continuity between BCM harness connector and ground.





Does continuity exist?
YES - Repair the harness or connector.
NO - Replace BCM. Refer to Exploded View.
3.CHECK REAR WIPER MOTOR (AUTO STOP) OPEN CIRCUIT
1. Turn the ignition switch OFF.
2. Disconnect BCM connector.
3. Check continuity between BCM harness connector and rear wiper motor harness connector.





Does continuity exist?
YES - Replace rear wiper motor.
NO - Repair the harness or connector.