C1A38

C1A38 ACCELERATOR PEDAL ACTUATOR CAN 1





Description
- ITS communication is a multiplex communication system. This enables the system to transmit and receive large quantities of data at high speed by connecting ICC sensor integrated unit, brake booster control unit, and accelerator pedal actuator with 2 communication lines.
- ITS communication lines adopt twisted-pair line style (two lines twisted) for noise immunity.




DTC Logic

DTC DETECTION LOGIC

DTC Detection Logic:

NOTE:
If DTC "C1A38" is detected along with DTC "U1000", first diagnose the DTC "U1000". Refer to DCA DCA DCA DCA

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Start the engine.
2. Turn the DCA switch ON.
3. Perform "All DTC Reading" with CONSULT-III.
4. Check if the "C1A38" is detected as the current malfunction in self-diagnosis results of "ICC".
Is "C1A38" detected as the current malfunction?
YES - Refer to C1A38.
NO - Refer to Intermittent Incident.




Diagnosis Procedure
1.CHECK ICC SENSOR INTEGRATED UNIT SELF-DIAGNOSIS RESULTS
Check if "U1000" is detected other than "C1A38" in "Self Diagnostic Result" of "ICC".
Is "U1000" detected?
YES - Perform the CAN communication system inspection. Repair or replace the malfunctioning parts. Refer to DCA.
NO - GO TO 2.
2.REPLACE ACCELERATOR PEDAL ASSEMBLY
1. Turn the ignition switch OFF.
2. Replace the accelerator pedal assembly.
3. Erases All self-diagnosis results.
4. Perform "All DTC Reading" again.
5. Check if the "C1A38" is detected in self-diagnosis results of "ICC".
Is "C1A38" detected?
YES - Replace the ICC sensor integrated unit. Refer to Exploded View.
NO - INSPECTION END




Special Repair Requirement

DESCRIPTION
Perform the action test after adjusting the laser beam aiming of ICC sensor integrated unit when the following operation is performed.
- Removal and installation of ICC sensor integrated unit
- Replacement of ICC sensor integrated unit
Check the operation after performing the accelerator pedal released position learning when the following operation is performed.
- Disconnection and connection of accelerator pedal position sensor connector
- Replace accelerator pedal assembly

SPECIAL REPAIR REQUIREMENT
1.CHECK CONTROL UNIT REPLACED, REMOVED AND/OR INSTALLED
Perform the adjustment work after the replacement or removal and installation of ICC sensor integrated unit, replacement of accelerator pedal assembly, or disconnection or connection of accelerator pedal position sensor connector.
Which is replaced, removed or installed?
ICC sensor integrated unit-GO TO 2.
Accelerator pedal assembly-GO TO 3.
2.LASER BEAM AIMING ADJUSTMENT OF ICC SENSOR INTEGRATED UNIT
Adjust the laser beam aiming of the ICC sensor integrated unit. Refer to ICC (Full Speed Range) ICC (Full Speed Range) Description
- GO TO 4.
3.ACCELERATOR PEDAL RELEASED POSITION LEARNING
Perform the Accelerator Pedal Released Position Learning. Refer to Description Special Repair Requirement Description Special Repair Requirement Description Special Repair Requirement, "ACCELERATOR PEDAL
Special Repair Requirement Description Special Repair Requirement Description Special Repair Requirement
- GO TO 4.
4.CHECK DCA SYSTEM
1. Erase the self-diagnosis results, and then perform "All DTC Reading" again after performing the action test. (Refer to DCA for action test.)
2. Check that the DCA system is normal.
- WORK END