P0732

P0732 A/T 2ND GEAR FUNCTION





Description
This malfunction is detected when the A/T does not shift into 2nd gear position as instructed by TCM. This is not only caused by electrical malfunction (circuits open or shorted) but by mechanical malfunction such as control valve sticking, improper solenoid valve operation, etc.




DTC Logic

DTC DETECTION LOGIC

DTC Detection Logic:

DTC CONFIRMATION PROCEDURE

CAUTION:
- " P0732" must be performed before starting "DTC CONFIRMATION PROCEDURE".
- Never perform "DTC CONFIRMATION PROCEDURE" before completing the repair, which may cause secondary malfunction.
- Always drive vehicle at a safe speed.
1.PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
- GO TO 2.
2.CHECK ATF TEMPERATURE
With CONSULT-III
1. Start the engine.
2. Select "ATF TEMP 1" with "Data Monitor".
3. Check ATF temperature is in the following range.

ATF TEMP 1 : 20�C (68�F) ? 140�C (284�F)

With GST
1. Start the engine.
2. Drive vehicle for approximately 5 minutes in urban areas.
Is ATF temperature within specified range?
YES - GO TO 3.
NO - Drive vehicle to warm ATF or stop engine to cool ATF.
3.CHECK SYMPTOM (PART 1)
With CONSULT-III
1. Select "2ND GR FNCTN P0732" of "DTC and SRT confirmation".
2. Drive vehicle with manual mode and maintain the following conditions.

GEAR : 2
ACCELE POSI : 0.7/8 or more
VEHICLE SPEED : 10 km/h (7 MPH) or more

3. Keep the current driving status for 2 seconds or more if CONSULT-III screen changes from "OUT OF
CONDITION" to "TESTING".

CAUTION:
If "TESTING" does not appear on CONSULT-III for a long time, select "Self Diagnostic Results". In case a 1st trip DTC other than "P0732" is shown, refer to "Self Diagnostic Results". Refer to Scan Tool Testing and Procedures.
With GST
1. Drive vehicle and maintain the following conditions for 2 seconds or more.

Selector lever : "M" position
Gear position : 2nd
Accelerator pedal opening : 0.7/8 or more
Vehicle speed : 10 km/h (7 MPH) or more

2. Check DTC.
Is "OUT OF CONDITION", "STOP VEHICLE" or "COMPLETED RESULT NG" displayed? / Is "P0732" detected?
YES-1 - "OUT OF CONDITION": Perform "Step 3" again.
YES-2 - "STOP VEHICLE": GO TO 4.
YES-3 - "COMPLETED RESULT NG": Go to P0732.
YES-4 - "P0732" is detected: Go to P0732.
NO - Check intermittent incident. Refer to Intermittent Incident.
4.CHECK SYMPTOM (PART 2)
With CONSULT-III
1. Stop vehicle.
2. Drive vehicle in "D" position allowing it to shift from 1st to 7th gear and check shift timing and shift shock.
- INSPECTION END




Diagnosis Procedure
1.CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident.
Is the inspection result normal?
YES - Replace A/T assembly. Refer to Exploded View.
NO - Repair or replace damaged parts.