With Rear Active Steer

U1000 CAN COMM CIRCUIT





Description
CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-H line, CAN-L line) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads required data only.




DTC Logic

DTC DETECTION LOGIC

DTC Detection Logic:

DTC CONFIRMATION PROCEDURE
1.DTC REPRODUCTION PROCEDURE
With CONSULT-III
1. Turn the ignition switch from OFF to ON.
2. Perform RAS control unit self-diagnosis.
Is DTC "U1000" detected?
YES - Proceed to diagnosis procedure. Refer to With Rear Active Steer.
NO - INSPECTION END




Diagnosis Procedure
1.PERFORM SELF-DIAGNOSIS
Perform RAS control unit self-diagnosis.
Is DTC "U1000" detected?
YES - Perform CAN diagnosis. Refer to CAN System Specification Chart.
NO - INSPECTION END.




Special Repair Requirement

BEFORE REPLACING RAS CONTROL UNIT
- Record the self-diagnosis results (history).

CAUTION:
- Never erase the memory (history) of self-diagnosis results when replacing RAS control unit after diagnosis.
- Erase the memory of the self-diagnosis results (record) after printing out or recording all the values of "DATA MONITOR".