Diagnosis Procedure

KEY SLOT ILLUMINATION


Description

Blinks when Intelligent Key insertion is required.




KEY SLOT ILLUMINATION


Diagnosis Procedure

1.CHECK FUSE
1. Turn ignition switch OFF.
2. Check 10 A fuse, [No.9, located in fuse block (J/B)].
Is fuse fusing?
YES - Replace the blown fuse after repairing the affected circuit if a fuse is blown.
NO - GO TO 2.
2.CHECK KEY SLOT ILLUMINATION OUTPUT SIGNAL
Check voltage between key slot harness connector and ground.





Is the inspection result normal?
YES - GO TO 3.
NO - GO TO 4.
3.CHECK KEY SLOT CIRCUIT
1. Disconnect BCM and key slot connector.
2. Check continuity between BCM harness connector and key slot harness connector.





3. Check continuity between BCM harness connector and ground.





Is the inspection result normal?
YES - Replace BCM. Refer to Removal and Installation.
NO - Repair or replace harness.
4.CHECK KEY SLOT POWER SUPPLY CIRCUIT
1. Disconnect key slot connector.
2. Check voltage between key slot harness connector and ground.





Is the inspection result normal?
YES - GO TO 5.
NO - Repair or replace harness.
5.CHECK KEY SLOT GROUND CIRCUIT
Check continuity between key slot harness connector and ground.





Is the inspection result normal?
YES - GO TO 6.
NO - Repair or replace harness.
6.CHECK KEY SLOT
Refer to Component Inspection.
Is the inspection result normal?
YES - GO TO 7.
NO - Replace key slot. Refer to Removal and Installation.
7.CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident.
- INSPECTION END