Check Change over Switch Circuit

REVERSE INTERLOCK DOOR MIRROR SYSTEM


Check Change over Switch Circuit

1.CHECK CHANGE OVER SWITCH SIGNAL
With CONSULT-III
Check the operation on (MIR CHNG SW-R" or "MIR CHNG SW-L) in the DATA MONITOR.





Without CONSULT-III
1. Turn ignition switch ON.
2. Check voltage between automatic drive positioner control unit connector and ground.










OK or NG
OK - Change over switch circuit is OK.
NG - GO TO 2.
2.CHECK HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit and door mirror remote control switch connector.
3. Check continuity between automatic drive positioner control unit connector and door mirror remote control switch connector.










4. Check continuity between automatic drive positioner control unit connector and ground.





OK or NG
OK - GO TO 3.
NG - Repair or replace harness.
3.CHECK CHANGE OVER SWITCH
Check door mirror remote control switch.










OK or NG
OK - GO TO 4.
NG - Replace door mirror remote control switch.
4.CHECK DOOR MIRROR REMOTE CONTROL SWITCH GROUND CIRCUIT
Check continuity between door mirror remote control switch connector and ground.










OK or NG
OK - GO TO 5.
NG - Repair or replace harness.
5.CHECK AUTOMATIC DRIVE POSITIONER CONTROL UNIT OUTPUT SIGNAL
1. Connect automatic drive positioner control unit connector.
2. Turn ignition switch ON.
3. Check voltage between automatic drive positioner control unit connector and ground.










OK or NG
OK - Check the condition of harness and connector.
NG - Replace automatic drive positioner control unit.