Check Door Mirror Sensor RH Circuit

AUTOMATIC DRIVE POSITIONER


Check Door Mirror Sensor RH Circuit

1.CHECK DOOR MIRROR FUNCTION
Check the following items.
Operation malfunction in memory operation.

NOTE:
If a door mirror face position is set to an implausible angle, the set position may not be reproduced.
OK or NG
OK - GO TO 2.
NG - Repair or replace the malfunctioning parts, and check the symptom again.
2.CHECK DOOR MIRROR RH SENSOR
With CONSULT-III
Check that "VOLTAGE" is displayed on "MIR/SEN RH R-L, MIR/SEN RH U-D" in the DATA MONITOR.





Without CONSULT-III
1. Turn ignition switch to ACC.
2. Check voltage between automatic drive positioner control unit connector and ground.










OK or NG
OK - Mirror sensor RH circuit is OK.
NG - GO TO 3.
3.CHECK HARNESS CONTINUITY 1
1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit connector and door mirror RH connector.
3. Check continuity between automatic drive positioner control unit connector and door mirror RH connector.










4. Check continuity between automatic drive positioner control unit connector and ground.





OK or NG
OK - GO TO 4.
NG - Repair or replace harness.
4.CHECK HARNESS CONTINUITY 2
1. Check continuity between automatic drive positioner control unit connector and door mirror RH connector.










2. Check continuity between automatic drive positioner control unit connector and ground.





OK or NG
OK - Replace door mirror RH.
NG - Repair or replace harness.