Check Remote Keyless Entry Receiver

INTELLIGENT KEY SYSTEM/ENGINE START FUNCTION


Check Remote Keyless Entry Receiver

1.CHECK POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect remote keyless entry receiver connector.
3. Check voltage between Intelligent Key unit connector and ground.










OK or NG
OK - GO TO 2.
NG - Replace Intelligent Key unit.
2.CHECK HARNESS CONTINUITY
1. Disconnect Intelligent Key unit connector.
2. Check continuity between Intelligent Key unit connector and remote keyless entry receiver connector.










3. Check continuity between Intelligent Key unit connector and ground.





OK or NG
OK - GO TO 3.
NG - Repair or replace harness between Intelligent Key unit and remote keyless entry receiver.
3.CHECK REMOTE KEYLESS ENTRY RECEIVER
1. Replace remote keyless entry receiver.
2. Connect Intelligent Key unit and remote keyless entry receiver connector. Check function the Intelligent
Key is carried into the inside key antenna detection area and the ignition switch is turned to START.
OK or NG
OK - Remote keyless entry receiver is malfunction.
NG - Remote keyless entry receiver is OK. If its malfunction is the same malfunction that occurred before performing the Remote Keyless Entry Receiver Circuit Inspection, it is not a malfunction in the remote keyless entry receiver circuit.