Removal and Replacement

FRONT DOOR GLASS AND REGULATOR


Removal and Installation







DOOR GLASS

Removal
1. Remove the front door finisher. Refer to Door Finisher Service and Repair.
2. Remove the front door sash cover inner. Refer to Door Finisher.





3. Operate the power window main switch to raise/lower the door window until the glass mounting bolts can be seen.
4. Remove the glass mounting bolts.





5. While holding the door glass, raise it at the rear end to pull the glass out of the sash toward the inside of the door.

Installation
Install in the reverse order of removal.

REGULATOR ASSEMBLY

Removal
1. Remove the front door finisher. Refer to Door Finisher Service and Repair.





2. Operate the power window main switch to raise/lower the door window until the glass mounting bolts can be seen.
3. Remove the glass mounting bolts.





4. Raise up the door glass and hold with a suction lifter A.
5. Remove the mounting bolts, and remove the module assembly.
6. Disconnect the harness connector for the module assembly, and unclip the harness from the inside.

Installation
Install in the reverse order of removal.

Inspection after Removal
Check the regulator assembly for the following items. If a malfunction is detected, replace or grease it.





- Wire wear
- Regulator deformation
- Grease condition for each sliding part
The arrows in the figure show the application points of the multi-purpose grease.