P1757

DTC P1757 FRONT BRAKE SOLENOID VALVE





Description
Front brake solenoid valve is controlled by the TCM in response to signals sent from the PNP switch, vehicle speed sensor and accelerator pedal position sensor (throttle position sensor). Gears will then be shifted to the optimum position.




CONSULT-III Reference Value in Data Monitor Mode









On Board Diagnosis Logic
- This is an OBD-II self-diagnostic item.
- Diagnostic trouble code "P1757 FR/B SOLENOID/CIRC" with CONSULT-III is detected under the following conditions.
- When TCM detects an improper voltage drop when it tries to operate the solenoid valve.
- When TCM detects as irregular by comparing target value with monitor value.




Possible Cause
- Harness or connectors
(The solenoid circuit is open or shorted.)
- Front brake solenoid valve




DTC Confirmation Procedure

CAUTION:
Always drive vehicle at a safe speed.

NOTE:
If "DTC Confirmation Procedure" has been previously performed, always turn ignition switch "OFF" and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-III
1. Turn ignition switch "ON". (Do not start engine.)
2. Select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
3. Start engine.
4. Drive vehicle and maintain the following conditions for at least 5 consecutive seconds.
ACCELE POSI: 1.5/8 - 2.0/8
SLCT LVR POSI: "D" position
GEAR: 3rd ⇒ 4th Gear (FR/B ON/OFF)
Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.
5. If DTC is detected go to P1757.

WITH GST
Follow the procedure "With CONSULT-III".




Diagnosis Procedure
1.CHECK INPUT SIGNAL
With CONSULT-III
1. Turn ignition switch "ON".
2. Select "MAIN SIGNALS" in "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
3. Start engine.
4. Read out the value of "FR/B SOLENOID" while driving.





OK or NG
OK - GO TO 4.
NG - GO TO 2.
2.CHECK TCM POWER SUPPLY AND GROUND CIRCUIT
Check TCM power supply and ground circuit. Refer to Main Power Supply and Ground Circuit.
OK or NG
OK - GO TO 3.
NG - Repair or replace damaged parts.
3.DETECT MALFUNCTIONING ITEM
Check the following items:
- The A/T assembly harness connector pin terminals for damage or loose connection with harness connector.
OK or NG
OK - Replace the control valve with TCM. Refer to Service and Repair.
NG - Repair or replace damaged parts.
4.CHECK DTC
Perform "DTC Confirmation Procedure".
- Refer to P1757.
OK or NG
OK >> INSPECTION END
NG - GO TO 2.