Vehicle Does Not Decelerate By Engine Brake

SYSTEM SYMPTOM


Vehicle Does Not Decelerate By Engine Brake


SYMPTOM:
No engine brake is applied when the gear is shifted from the 22 to 11.

DIAGNOSTIC PROCEDURE
1.CHECK SELF-DIAGNOSIS RESULTS
Perform self-diagnosis.
Do the self-diagnosis results indicate PNP switch?
YES - Check the malfunctioning system. Refer to P0705.
NO - GO TO 2.
2.CHECK 1ST POSITION SWITCH CIRCUIT
With CONSULT-III
1. Turn ignition switch "ON".
2. Select "ECU INPUT SIGNALS" in "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
3. Read out "1 POSITION SW" moving switch selector lever to each position.





Without CONSULT-III





1. Turn ignition switch "ON".(Do not start engine)
2. Check voltage between A/T device harness connector terminal and ground.





OK or NG
OK - GO TO 3.
NG - Repair or replace damaged parts.
3.CHECK A/T FLUID LEVEL





Check the A/T fluid level. Refer to Checking The A/T Fluid (ATF).
OK or NG
OK - GO TO 4.
NG - Refill ATF.
4.CHECK CONTROL CABLE





Check the control cable.
- Refer to Checking of A/T Position.
OK or NG
OK - GO TO 5.
NG - Adjust control cable. Refer to Adjustment of A/T Position Checking of A/T Position, "Adjustment of A/ T Position".
5.CHECK A/T FLUID CONDITION
1. Remove oil pan. Refer to Service and Repair.





2. Check A/T fluid condition. Refer to Checking The A/T Fluid (ATF), "Checking the A/T
Fluid (ATF)".
OK or NG
OK - GO TO 6.
NG - GO TO 9.
6.DETECT MALFUNCTIONING ITEM
- Check the malfunction items. If any items are damaged, repair or replace damaged parts. Refer to Symptom Table ((Symptom No.53).
OK or NG
OK - GO TO 7.
NG - Repair or replace damaged parts.
7.CHECK SYMPTOM
Check again. Refer to Cruise Test - Part 3
OK or NG
OK >> INSPECTION END
NG - GO TO 8.
8.PERFORM TCM INSPECTION
1. Perform TCM input/output signals inspection. Refer to A/T Control System
2. If NG, recheck A/T assembly harness connector terminals for damage or loose connection with harness connector.
OK or NG
OK >> INSPECTION END
NG - Repair or replace damaged parts.
9.DETECT MALFUNCTIONING ITEM
- Check the malfunction items. If any items are damaged, repair or replace damaged parts. Refer to Symptom Table (Symptom No.53).
OK or NG
OK - GO TO 7.
NG - Repair or replace damaged parts.