C1F01

C1F01 ACCELERATOR PEDAL ACTUATOR





Description
- The accelerator pedal actuator is integrated into the accelerator pedal assembly.
- The accelerator pedal actuator consists of the control unit and motor.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn the ignition switch OFF.
2. Turn the ignition switch ON.
3. Slowly depress the accelerator pedal completely, and then release it.
4. Repeat step 3 several times.
5. Perform "All DTC Reading" with CONSULT-III.
6. Check if the DTC "C1F01" is detected as the current malfunction on the self-diagnosis results of "ICC" or "ACCELE PEDAL ACT".
Is "C1F01" detected as the current malfunction?
YES - C1F01.
NO - Intermittent Incident.




Diagnosis Procedure
1.REPLACE ACCELERATOR PEDAL ASSEMBLY
Perform DTC confirmation procedure. If "C1F01" is detected as the current malfunction, replace the accelerator pedal assembly. C1F01.
- INSPECTION END




Special Repair Requirement

DESCRIPTION
The accelerator pedal released position learning is necessary when the following operation is performed.
- Disconnection and connection of accelerator pedal assembly connector
- Replace accelerator pedal assembly

SPECIAL REPAIR REQUIREMENT
1.ACCELERATOR PEDAL RELEASED POSITION LEARNING
Perform the accelerator pedal released position learning. Description Special Repair Requirement Description Special Repair Requirement Description Special Repair Requirement, "ACCELERATOR PEDAL
Special Repair Requirement Description Special Repair Requirement Description Special Repair Requirement, "ACCELERATOR PEDAL
RELEASED POSITION LEARNING : Description" (VK50VE).
- GO TO 2.
2.CHECK DCA SYSTEM
1. Erase the "self-diagnosis results", and then perform "All DTC Reading" again after performing the action test. ( DCA for action test.)
2. Check that the DCA system is normal.
- WORK END