7AT RE7R01A

P0731 1GR INCORRECT RATIO





Description
This malfunction is detected when the A/T does not shift into 1GR position as instructed by TCM. This is not only caused by electrical malfunction (circuits open or shorted) but by mechanical malfunction such as control valve sticking, improper solenoid valve operation, etc.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE

CAUTION:
- " 7AT RE7R01A" must be performed before starting "DTC CONFIRMATION PROCEDURE".
- Never perform "DTC CONFIRMATION PROCEDURE" before completing the repair, which may cause secondary malfunction.
- Always drive vehicle at a safe speed.
1.PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
- GO TO 2.
2.CHECK ATF TEMPERATURE
With CONSULT-III
1. Start the engine.
2. Select "ATF TEMP 1" in "Data Monitor" in "TRANSMISSION".
3. Check ATF temperature is in the following range.

ATF TEMP 1: 20°C (68°F) - 140°C (284°F)

With GST
1. Start the engine.
2. Drive vehicle for approximately 5 minutes in urban areas.
Is ATF temperature within specified range?
YES - GO TO 3.
NO - Drive vehicle to warm ATF or stop engine to cool ATF.
3.CHECK SYMPTOM (PART 1)
With CONSULT-III
1. Select "1ST GR FNCTN P0731" in "DTC & SRT confirmation" in "TRANSMISSION".
2. Drive vehicle with manual mode and maintain the following conditions.

GEAR: 1
ACCELE POSI: 0.7/8 or more
VEHICLE SPEED: 10 km/h (7 MPH) or more

3. Keep the current driving status for 2 seconds or more if CONSULT-III screen changes from "OUT OF CONDITION" to "TESTING".

CAUTION:
When "TESTING" is not indicated on CONSULT-III for a long time, check "Self Diagnostic Results" in "TRANSMISSION". When a DTC other than "P0731" is detected, check the DTC. TCM.
With GST
1. Drive vehicle and maintain the following conditions for 2 seconds or more.

Selector lever: "M" position
Gear position: 1st
Accelerator pedal opening: 0.7/8 or more
Vehicle speed: 10 km/h (7 MPH) or more

2. Check DTC.
Is "OUT OF CONDITION", "STOP VEHICLE" or "COMPLETED RESULT NG" displayed? / Is "P0731" detected?
YES-1 - "OUT OF CONDITION": Perform "Step 3" again.
YES-2 - "STOP VEHICLE": GO TO 4.
YES-3 - "COMPLETED RESULT NG": Go to 7AT RE7R01A.
YES-4 - "P0731" is detected: Go to 7AT RE7R01A.
NO - Check intermittent incident. How to Perform Efficient Diagnosis For an Electrical Incident.
4.CHECK SYMPTOM (PART 2)
With CONSULT-III
1. Stop vehicle.
2. Drive vehicle in "D" position allowing it to shift from 1GR to 7GR and check shift timing and shift shock.
- INSPECTION END




Diagnosis Procedure
1.CHECK INTERMITTENT INCIDENT
How to Perform Efficient Diagnosis For an Electrical Incident.
Is the inspection result normal?
YES - Replace A/T assembly. Exploded View.
NO - Repair or replace damaged parts.