Without Navigation

STEERING SWITCH SIGNAL A CIRCUIT


WITHOUT NAVIGATION : Description

Transmits the steering switch signal to AV control unit.




STEERING SWITCH SIGNAL A CIRCUIT


WITHOUT NAVIGATION : Diagnosis Procedure

1.CHECK STEERING SWITCH SIGNAL A CIRCUIT
1. Disconnect AV control unit connector and spiral cable connector.
2. Check continuity between AV control unit harness connector terminal 6 and spiral cable harness connector terminal 33.

6 - 33: Continuity should exist.

3. Check continuity between AV control unit harness connector terminals 6 and ground.

6 - Ground: Continuity should not exist.

Is the inspection result normal?
YES - GO TO 2.
NO - Repair harness or connector.
2.CHECK SPIRAL CABLE
Check spiral cable.
Is the inspection result normal?
YES - GO TO 3.
NO - Replace spiral cable.
3.CHECK AV CONTROL UNIT VOLTAGE
1. Connect AV control unit connector and spiral cable connector.
2. Turn ignition switch ON.
3. Check voltage between AV control unit harness connector terminals 6 and 15.

6 - 15: Approx. 3.3 V

Is the inspection result normal?
YES - GO TO 4.
NO - Replace AV control unit.
4.CHECK STEERING SWITCH
1. Turn ignition switch OFF.
2. Check steering switch. Without Navigation.
Is the inspection result normal?
YES - INSPECTION END
NO - Replace steering switch.