ID Registration Procedure

TROUBLE DIAGNOSIS


ID Registration Procedure


ID REGISTRATION WITH ACTIVATION TOOL
This procedure must be done after replacement of a tire pressure transmitter, low tire pressure warning control unit, or tire rotation.
1. Touch "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".





2. With the activation tool (J-45295) pushed against the front-left tire pressure transmitter position of the tire air valve, press and hold the button for 5 seconds.
3. Register the IDs in order from FR LH, FR RH, RR RH, RR LH.
When ID registration of each wheel has been completed, turn signal lamp blinks.





4. After completing all ID registrations, press "END" to complete the procedure.

NOTE:
Be sure to register the IDs in order from FR LH, FR RH, RR RH, to RR LH, or the self-diagnosis results display will not function properly.

ID REGISTRATION WITHOUT ACTIVATION TOOL
This procedure must be done after replacement of a tire pressure transmitter, low tire pressure warning control unit, or tire rotation.
1. Touch "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
2. Adjust the tire pressure to the values shown in the table below for ID registration, and drive the vehicle at
40 km/h (25 MPH) or more for a few minutes.





3. After completing all ID registrations, press "END" to complete the procedure.





4. Inflate all tires to proper pressure. Specifications Specifications.