AFS Operation Check (Function Test)

ACTIVE AFS


AFS Operation Check (Function Test)

1.CHECK SWIVEL ACTUATOR
CONSULT-III ACTIVE TEST
1. Start engine and turn lighting switch to 2ND position.
2. Select "LOW BEAM TEST RIGHT" or "LOW BEAM TEST LEFT" of ADAPTIVE LIGHT active test item.
3. Touch "ORIGIN�FAST/SLOW" and "PEAK�FAST/SLOW" screen.
4. Make sure of swivel operation.





OK or NG
OK - GO TO 2.
NG -
- When interference or poor fitment is found, perform aiming adjustment. Adjustments. If it is normal, replace headlamp. Active AFS.
- When the operation range is irregular, perform aiming adjustment. Adjustments. If it is normal, GO TO 3.
2.CHECK STEERING ANGLE SENSOR
CONSULT-III DATA MONITOR
Check "STR ANGLE SIG" in "Data Monitor" when driving straight and steering turn 90� to right or left.





OK or NG
OK - GO TO 3.
NG -
- When steering is out of range while driving straight, perform steering angle sensor adjustment. in "ON-VEHICLE SERVICE".
- When the function is normal while driving straight but the displayed value is different from actual steering position with turning to right or left, replace steering angle sensor. Active AFS.
3.CHECK SWIVEL ACTUATOR AND AFS CONTROL UNIT
CONSULT-III DATA MONITOR
Check "SWVL SEN RH/LH" and "SWVL ANGLE RH/LH" in "Data Monitor" with steering turning to right or left under swivel operative condition.





OK or NG
OK - AFS function is normal.
- � When the difference is 4.5� or more between the displayed value on "SWVL ANGLE" and that
NG on "SWVL SEN", replace headlamp.
- When the displayed angle on "SWVL ANGLE" is irregular, replace AFS control unit.