Removal and Installation
SPARK PLUG
Removal and Installation
REMOVAL
1. Disconnect the harness connector from the ignition coil.
2. Remove ignition coil.
CAUTION:
Do not shock ignition coil.
3. Remove spark plug using suitable tool.
INSPECTION AFTER REMOVAL
- Do not use a wire brush for cleaning.
- If plug tip is covered with carbon, spark plug cleaner may be used.
Cleaner air pressure: Less than 588 kPa (5.9 bar, 6 kg/cm2, 85 psi)
Cleaning time: Less than 20 seconds
- Checking and adjusting plug gap is not required between change intervals.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Do not drop or shock spark plug.