LDW & LDP

DIAGNOSIS AND REPAIR WORK FLOW


Work Flow


OVERALL SEQUENCE






DETAILED FLOW
1.INTERVIEW FOR MALFUNCTION
Interview the customer to obtain information about symptoms using "Diagnostic Work Sheet". ( Diagnostic Work Sheet.)
- GO TO 2.
2.SELF-DIAGNOSIS WITH CONSULT-III
Perform self-diagnosis with CONSULT-III. Check if any DTC is detected.
Is any DTC detected?
YES - GO TO 5.
NO - GO TO 3.
3.PRE-INSPECTION FOR DIAGNOSIS
Perform pre-inspection for diagnosis. LDW & LDP.
- GO TO 4.
4.VERIFY CUSTOMER CONCERN (ACTION TEST)
Perform action test and verify the customer's information. LDW & LDP.
- GO TO 6.
5.TROUBLE DIAGNOSIS BY DTC
Perform trouble diagnosis for the detected DTC. Specify a malfunctioning part. Testing and Inspection(Lane camera unit) and/or Testing and Inspection [ABS actuator and electric unit (control unit)].
- GO TO 7.
6.SYMPTOM DIAGNOSIS
Perform symptom diagnosis. Specify malfunctioning part. LDW & LDP System Symptoms.
- GO TO 7.
7.MALFUNCTION PART REPAIR
Repair or replace the identified malfunctioning parts.
- GO TO 8.
8.REPAIR CHECK (SELF-DIAGNOSIS WITH CONSULT-III)
Perform self-diagnosis with CONSULT-III. Check that any DTC is not detected. Erase DTC if DTC is detected before the repair. Check that DTC is not detected again.
Is any DTC detected?
YES - GO TO 5.
NO - GO TO 9.
9.REPAIR CHECK (ACTION TEST)
Perform action test. Also check the system operation.
Does it operate normally?
YES - INSPECTION END
NO - GO TO 4.