Door Mirror Motor

DOOR MIRROR MOTOR





Description
It makes mirror face operate from side to side and up and down with the electric power that AUTOMATIC
DRIVE POSITIONER CONTROL UNIT supplies.




Component Function Check
1.CHECK DOOR MIRROR MOTOR FUNCTION
Check the operation with "MIRROR MOTOR RH" and "MIRROR MOTOR LH" in "ACTIVE TEST" mode with
CONSULT-III
Scan Tool Testing and Procedures.
Is the inspection result normal?
YES - INSPECTION END
NO - SEE Diagnosis Procedure.




Diagnosis Procedure
1.CHECK DOOR MIRROR MOTOR INPUT SIGNAL
1. Turn ignition switch ON.
2. Check voltage between door mirror connector and ground.





Is the inspection result normal?
YES - GO TO 3.
NO - GO TO 2.
2.CHECK HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit connector.
3. Check continuity between automatic drive positioner control unit connector and door mirror connector.





4. Check continuity between automatic drive positioner control unit connector and ground.





Is the inspection result normal?
YES - Replace automatic drive positioner control unit. Removal And Installation.
NO - Repair or replace harness or connector.
3.CHECK DOOR MIRROR MOTOR
Check door mirror motor. SEE Component Inspection.
Is the inspection result normal?
YES - GO TO 4.
NO - Replace door mirror. Removal And Installation With ADP.
4.CHECK INTERMITTENT INCIDENT
Intermittent Incident.
- INSPECTION END




Component Inspection
1.CHECK DOOR MIRROR MOTOR-I
Check that door mirror motor does not trap foreign objects and does not have any damage. With ADP.
Is the inspection result normal?
YES - GO TO 2.
NO - Replace door mirror. Removal And Installation With ADP.
2.CHECK DOOR MIRROR MOTOR-II
1. Turn ignition switch OFF.
2. Disconnect door mirror connector.
3. Apply 12V to each power supply terminal of door mirror motor.





Is the inspection result normal?
YES - INSPECTION END
NO - Replace door mirror. Removal And Installation With ADP.