Work Procedure

TRANSMITTER WAKE UP OPERATION


Work Procedure

1.TRANSMITTER WAKE-UP PROCEDURE
1. Turn the ignition switch ON.

CAUTION:
Never start the engine.

NOTE:
The position of an inactive transmitter can be identified by checking the blinking timing of the low tire pressure warning lamp.










2. Contact the transmitter activation tool (J-45295) (1) to the side of the tire at the location to the transmitter.
3. Press and hold the activation tool button while pushing the tool to the tire surface. (approximately for 5 seconds)

CAUTION:
Perform the wake-up procedure starting from the vehicle front left wheel, then repeat the procedure in the order of the front right wheel, rear right wheel, and rear left wheel.
4. Check that the turn signal lamps blink twice when the transmitter wake-up procedure for all wheels is completed.
5. Check that the low tire pressure warning lamp turns OFF, after the transmitter wake-up procedure is completed for all wheels and turns OFF.
Is the transmitter wake-up procedure completed?
YES - Perform the transmitter ID registration procedure. ID Registration.
NO - Perform trouble diagnosis for the transmitter. C1708.